[Boldlygo]

So, I've installed my pedals, but ran into one issue. The dead pedal here in Canada is part of the carpet. It does not come out. So what I did was use an 1/8" drill bit and drilled out three holes in the dead pedal (there are actually 3 hole places, 2 on the bottom, one on the top) where the drill bit fits perfectly. I then used 3 black self-tapping screws to simply screw in the dead pedal to the rubber foot rest. I also slit four slots on the floor where the dead pedal had the clips to attach to the plastic piece in the kit.
This procedure worked fine!