Lexus CT200h Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
516 Posts
Discussion Starter · #1 ·
I know I posted this on this forum recently but can't find it. I ordered and received in the mail yesterday the rear metal bumper protector...it mounts on the bumper using the double sided sticky tape it comes with. I know someone out there has purchased it as well. If anyone has a picture of one installed please post so I can see what it looks like. I may have the dealer put it on as I want to make sure it comes out straight.
 

·
Registered
Joined
·
842 Posts
http://lexus.sewellparts.com/pdf/PT92276110.pdf

I
don't think you will get any better insight than this instruction on how to install it.

It is really not all that hard, in fact it might be easier than the rubber one (which I installed myself) because it is more firm and doesn't flop around as much. Put it on the rear bumper with the adhesive still covered up and then mark where the ends are with something you can wipe off. Try closing your rear hatch (the one on the car, that is) to make sure it doesn't touch it. Very simple, IMO.

The page which shows the part has three pictures of it installed. That page is here: http://lexus.sewellparts.com/accessories-catalog/Exterior/CT200h-2012/4573.html

I
f you want to wait a few days I will be putting mine on. Kind of busy now and I have to remove the rubber one I put on while the chrome one was not available.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top